Knowledgebase
Eurostyle Eyewear Customer Service > Customer Service > Knowledgebase

Ask a question:


Fitting Guidelines X-IDE Model Eggert, Porto Cervo, Stem

Solution

EGGERT, PORTO CERVO, STEM

WARNING: LENSES MUST BE CUT USING THE FORMER PROVIDED


FRONT ADJUSTMENT

Front can be adjusted by using a hot air warmer at temperatures between 40°C - 50°C for approximately 20-30 seconds.

WARNING: Do not overheat the temples. This will damage the epoxy resin causing it to bubble. Hot water can also be used to adjust as well. Use the same time & temperature guidlines as for hot air.

WARNING: Do not adjust the frame cold. since this could cause the epoxy to crack.

Attachments:
Fitting-EGGERT-PORTO-CERVO-STEM.pdf Fitting-EGGERT-PORTO-CERVO-STEM.pdf

 
Was this article helpful? yes / no
Article details
Article ID: 5
Category: Fitting Guidelines
Date added: 14-08-2014 18:30:18
Views: 360
Rating (Votes): Article rated 3.1/5.0 (23)

 
« Go back

 
Powered by Help Desk Software HESK - brought to you by Help Desk Software SysAid